The Racing Magazine in the Islands
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Project S14 Zenki
Goto page Previous  1, 2, 3 ... 11, 12, 13, 14  Next
 
Post new topic   Reply to topic    Zorce.com Forum Index -> The Secret Project Room (tsk)
View previous topic :: View next topic  
Author Message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Mon Jun 14, 2010 12:31 pm    Post subject: Reply with quote

You're right, I can't find the part number either. The lip came standard on the SE models in the US along with 5 lug hubs and the white face gauge cluster. You can find the lip used from time to time on the various forums up here. Who needs the lip? I'll trade you my whole bumper/fogs/lip for a Navan front bumper.

I have been meaning to update this thread. I finally installed the new Z32 front brakes and BMC. Did not do the rears yet. I'll get the pics up soon. I also got a front passenger side fender in the same colour to put on to replace the dented one. Dunno when I will get around to doing it as it requires pulling off the bumper, headlights and skirts to get the fender off.

The car is about to roll over to 190K miles. There was an oil leak that developed around the front main seal so I had to replace that. While I was there I also removed the timing chain guides so there is no more rattle can sound at idle. I have all the suspension arms and coilovers to install but I need to get a 2nd car so that I can still go to work while I have the S14 in pieces. I still refuse to take it to a mechanic.

Pics to follow.
_________________
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Sat Jun 19, 2010 2:57 pm    Post subject: Reply with quote

Some pics from the front brake swap:

Old set up with 9" rotors, single piston sliding calipers, rubber brake lines


New set up with 11" rotors, 4 piston calipers, braided brake lines


A comparison of the new vs old rotors


Finished product



Hands were dirty with brake fluid the rest of the time so did not get any shots of the master cylinder swap.
_________________


Last edited by Jahling on Sat Jul 31, 2010 6:50 am; edited 1 time in total
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Sat Jun 19, 2010 3:02 pm    Post subject: Reply with quote

Parked outside my apartment building earlier this spring:







The resemblance is amazing. I just have to lower my car a bit and then they will be twins.
_________________
Back to top
View user's profile Send private message
VK-Sportsman
Zorce Jedi Apprentice


Joined: 05 Nov 2005
Posts: 933

PostPosted: Sat Jun 19, 2010 8:24 pm    Post subject: Reply with quote

Nice brake setup!, Cool
I saw a pic of a zenki bumper lip on a 200SX SE-R, its the only cosmetic modification i'll ever do on the b14, but not right now, sometime in the future.
_________________
Feel the Power of the Racing Zorce
Back to top
View user's profile Send private message Visit poster's website
wagonrunner
Zorce Jedi Knight


Joined: 03 Sep 2005
Posts: 941
Location: this much in front of you.

PostPosted: Sun Jun 20, 2010 12:45 am    Post subject: Reply with quote


so all the vanes in the rotor were rusted / broken?
what the hell happened when the caliper squeezed?
grip & slip & grip & slip & slip & slip?
_________________
PROUD MEMBER OF D WAGON BOYZ @ DEX
I Refuse To Have A Battle Of Wits With Unarmed Persons


Any man who can hitch the length and breadth of the galaxy, rough it, slum it, struggle against terrible odds, win through, and still knows where his towel is, is clearly a man to be reckoned with.
Back to top
View user's profile Send private message Visit poster's website MSN Messenger
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Sun Jun 20, 2010 8:20 am    Post subject: Reply with quote

Nah they were not broken. That is just a lot of corrosion. This is what happens with winter and salt. The old ones were still solid but a bit warped so they got tossed into the dumpster.
_________________
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Mon Jul 26, 2010 10:01 pm    Post subject: Reply with quote

Coming soon to a S14 near you:





http://www.stance-usa.com/sus/products/coilovers/alpro
_________________
Back to top
View user's profile Send private message
MG Man
Zorce Klingon Warrior


Joined: 19 May 2005
Posts: 2683
Location: usually on the back page

PostPosted: Tue Jul 27, 2010 8:45 pm    Post subject: Reply with quote

suh-wheeeeeeeeeet Mr. Green
nice er...................AUDI logo there fella
PS HSR alive eh, and yuh seat time already reserved
_________________

I know it's so, for I told me so
Back to top
View user's profile Send private message
VK-Sportsman
Zorce Jedi Apprentice


Joined: 05 Nov 2005
Posts: 933

PostPosted: Tue Jul 27, 2010 9:00 pm    Post subject: Reply with quote

Jahling, what spring rates are those?
_________________
Feel the Power of the Racing Zorce
Back to top
View user's profile Send private message Visit poster's website
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Tue Jul 27, 2010 10:27 pm    Post subject: Reply with quote

MG Man wrote:

nice er...................AUDI logo there fella


Safety first. Better late than pregnant.

MG Man wrote:

PS HSR alive eh, and yuh seat time already reserved


Nice. I watch James May struggling with his dog leg gearbox the other day and I was real cracking up thinking of you doing that to the HSR. Who knows, by the time I reach back, yuh house and the MG go be finish.
_________________
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Tue Jul 27, 2010 10:33 pm    Post subject: Reply with quote

VK-Sportsman wrote:
Jahling, what spring rates are those?


8K front, 6K rear, 15 way adjustable.

The fronts are inverted monotube shocks - superior to the Tein twintube design. I went with the aluminum ones to save on unsprung weight.
_________________
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Sat Jul 31, 2010 7:18 am    Post subject: Reply with quote

Front install:






Front camber plates, pillowball upper mounts. You can also see the new 17/16th inch master cylinder



_________________
Back to top
View user's profile Send private message
MG Man
Zorce Klingon Warrior


Joined: 19 May 2005
Posts: 2683
Location: usually on the back page

PostPosted: Sat Jul 31, 2010 8:08 pm    Post subject: Reply with quote

WOW has your dad seen this?
I can just see his face light up!
_________________

I know it's so, for I told me so
Back to top
View user's profile Send private message
Jahling
Jedi Hopeful


Joined: 07 Apr 2005
Posts: 234
Location: Connecticut

PostPosted: Sat Jul 31, 2010 10:33 pm    Post subject: Reply with quote

Nah, he eh see any of this yet. I was waiting for him to see it in person. His reaction would be more like a big steups followed by "Why you spending all your money on this ole car instead of buying a house?"

I did tell him that I changed the shocks and the brakes but I did not get into too much details.
_________________
Back to top
View user's profile Send private message
Conrad
Pumpum Conqueror


Joined: 23 Aug 2008
Posts: 6

PostPosted: Sun Aug 01, 2010 1:19 am    Post subject: Reply with quote

Sweet suspension and brake setup!

Heading for some adjustable arms?
Back to top
View user's profile Send private message MSN Messenger
Display posts from previous:   
Post new topic   Reply to topic    Zorce.com Forum Index -> The Secret Project Room (tsk) All times are GMT - 5 Hours
Goto page Previous  1, 2, 3 ... 11, 12, 13, 14  Next
Page 12 of 14

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group